The AC50 is a programmable controller capable of 2MIPS with a corresponding interrupt latency of 2.5us. Parallel and CAN Bus interfaces are available along with 64 I/O pins. All I/O pins are protected with TVS devices and available on 2 x 36 pin connectors.

The AC50 is an adaptable controller with the following features:

• Based on Michrochip's dsPIC30F6010 capable of 2MIPS with a corresponding interrupt latency of 2.5us

• 64 general purpose I/O pins with ESD protection

• High speed CAN transceiver that supports speeds up to 1MB/s

• Small size

• Test and demo software with C source code

Prices: $100 each for 1; $80 each for 10; $60 each for 100; please contact us for other quantities

General terms and conditions are here.

Options

Regulator IC3 is not populated on a standard AC50. If it is needed, please request that on your order.

The AC50Basic is a low cost version without CAN transceiver, LEDs, resistors and resistor networks, capacitor, and connectors. Since the circuit board is the same, the components can be added as needed.

The AD5 is a cable that connects an AC50 to Microchip's ICD2 for development, debugging, and programming.

Extensive application development support is available by RenaiSys LLC (www.renaisys.com) at their regular rates and conditions. AC50 controllers have been used in wire harness testers.

Please contact us with any question, comment, or suggestion.

For copyright, trademark, and other legal information please read the linked pages. Adaptable Controllers LLC 2005 - 2008.